![]() ![]() (1) Capture sharpening aims to address any blurring caused by your image's source, while also taking image noise and detail into consideration. Output Sharpening Accounts for final output medium, after editing/resizing Each stage of the sharpening process can be categorized as follows: Most photographers now agree that sharpening is most effective and flexible when it's applied more than once during image editing. Optimal results may require a few iterations. It's generally advisable to first optimize the radius setting, then to adjust the amount, and then finally to fine-tune the results by adjusting the threshold/masking setting (and potentially other settings such as "detail"). You will therefore likely need to adjust this setting in conjunction with the amount/percent setting. Higher values emphasize fine detail, but also increase the overall sharpening effect. It's especially useful to avoid sharpening noise.Ĭontrols the relative sharpening of fine versus coarse detail (within a given radius value), in addition to affecting the overall strength of sharpening. This can be used to sharpen more pronounced edges, while leaving more subtle edges untouched. A good starting point is often a value of 100%.Ĭontrols the minimum brightness change that will be sharpened. You'll usually want a radius setting that is comparable to the size of the smallest detail within your image.Ĭontrols the overall strength of the sharpening effect, and is usually listed as a percentage. One can usually adjust at least three settings: SettingĬontrols the size of the edges you wish to enhance, where a smaller radius enhances smaller-scale detail. Note: all images shown at 200% zoom to improve visibility SETTINGSįortunately, most of the sharpening settings within image-editing software are reasonably standardized.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |